...machine ran went into spin but did not. Get the Thrust Bearing Kit - Includes the Pulley, Bearing, Plastic Gear. Make sure you mark the pulley, gear and shaft when removing the older pullet, bearing ...
...plastic gears. The teeth on the last plastic gear gets all chewed up so that the timer continues to run and unable to open the circuit which stops the dryer timer. Although the plastic gear probably ...
...cleaned it out but it still does not work. I can see that it is splashed out around the top basket plastic. 2. My husband replaced the coupler and the 4 dog agitators before too since it didn't seem ...
sounds like plastic gears grinding on each other Check for bones/glass/ceramic from chipped plates in the food chopper (for lack of a better term). You'll need to disassemble the entire lower arm unit
the gears are broken. Check to see if the small plastic arms that rest against the ice rake are broken. If the ice maker head assembly is modular and you've found broken parts, you can just replace it
Question about 24 in. MDB7600A Jetclean® II Built-in Dishwasher
plastic reduction gears between the timer motor and the gear that drives the knob, and one of them had the teeth stripped off. You can find them on ebay for less than $50 shipped rather than pay $100+
...there is no water in unit then pull white cover on icemaker and check gear assembly does the white plastic gear look broke or anything... see if the gear turns to the right with hand freely it
Question about Atlantis MAV6000 Top Load Washer
...plastic gears(not best description) above pulley and some shims(washers) You will need to read up a little to install correct washer to get right lift from pulley and gears to release brake for spin, ...
Question about Bravos 3.8 Cu. Ft. Washer
...tilt it back. Pull down the white insulation board. remove the two screws holding the white/clear plastic guard in place 5/16 nut driver. and check the gear and belt ours had come off. Now it works ...
Question about Bravos 3.8 Cu. Ft. Washer
...plastic griding The nut that holds the main biggest pulley under machine has worked loose. Depending on how long it's been grinding, pulley and splutch that gears on pulley seat against may need ...
Usually answered in minutes!
2,979 Questions
1,498 Questions
947 Questions
680 Questions
658 Questions