Questions & Answers for: plastic gears

Ad

Question about Infoguard Shredder SX102M

2 Answers

...plastic gears that I can send to you. The motor bracket on mine snapped. I took it apart to check. It looks unrepairable. [email protected] please give me a call at 770-855-7595 so I can have you send ...

Ad

Question about VF700 Cross-Cut Shredder

2 Answers

gears are plastic/metal each seperate- part numbers VF800 - 04 to 07, 04 and 06 are the plastic gears and 05/07 are the accompanying metal gears shipped priority post 2-4days -- too easy!! Royal VF700

Ad

Question about DM8C Cross-Cut Shredder

3 Answers

...plastic gears? Thank you. . I have a Fellowes DM8C and the large plastic gear has one sprocket missing. It is not a good idea to combine metal gears and plastic gears because the plastic gears wear ...

Question about 150MX Cross-Cut Shredder

1 Answer

replacement plastic gear for a Royal 150MX shredder The needed gear is the plastic gear that feeds off the motor shaft. A paper jam caused the motor shaft gear to chew a divot into the plastic gear. ...

PLASTIC GEARS FAILED? FELLOWES HAS A REPLACEMENT THAT CHANGES A PLASTIC GEAR TO A STEEL GEAR-A GREAT IMPROVEMENT. Hi. You can ring Staffords on 08457581545 for the Fellow shraders parts. Ali No, there

...gears. i think its a gear lever cable not sure doe any ideas? 2nd 4th and reverse gear means that you need to pull the gear knob (in passenger compartment) backwards which inversly push the gearbox's ...

The first neoprene (plastic) gear wheel that makes contact with motor shaft axel (Metal) is damaged. The metal shaft that has the teeth that match the neoprene (Plastic) has stripped the plastic teeth

Question about Pro PP4620AVX 46cc Gas Chainsaw With 20" Bar

2 Answers

gears in the adjusting wheel and one plastic gear. WHERE can I find a replacement for the plastic gear in the adjusting wheel? !! I can't use the chain saw because of one silly little plastic gear

Question about 106772 HandStand Mixer

0 Answer

plastic gears for mixer are worn down I need the two separate gears that are pressed or molded onto a plastic shaft approx. 1 3/8" long. The mixer attachments are inserted into these shafts and a

plastic case, and re-attached the fallen part. The alignment between the two gears is off, and I need to know the correct position before I get the bobbin to work; thread the bobbin with the needle. I

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Office Equipment & Supplies Experts

Ekse

Level 3 Expert

13435 Answers

The Knight
The Knight

Level 3 Expert

76823 Answers

Brad Brown

Level 3 Expert

18904 Answers

Are you an Office Equipment & Supplies Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...