Questions & Answers for: plasma cutter wont

Wont arc WHEN I HIT THE TRIGGER I GET LITTLE ARC TO NO ARC? If you have water in the system, bad tip or ground it wont spark properly Domo

plasma cutter wont cut steady It begins to cut but it just stops and then u have to let off the trigger and start again. It only cuts for like 30 seconds. I have checked the ground numerous times and ...

plasma problem the amber cup light on my miller spectrum 1251 keeps coming on and machine wont work check your torch and make sure nothing is loose. If that does not fix it you will need to ...

pilot wont lite. miller spectrum 701 pilot wont lite power/air. all good .just no pilot check the cables in the plasma torch. If the problem continues, theres no enough power to start it.

...plasma cutter just flashes fault everytime you try and use it. could it be the ground or would it be the electrod check the main lead to the torch,if there is a cut or any hole in the rubber coating ...

Plasma cutter no cutting I have recently bought a Extreme 375 that woudn't cut and they local welding shop told me moisture or oil had fried the circuit board. He explained the cost to replace the ...

I have the Hobart 250 model. I have gotten much use from it. Recently I was using it, I wouldnt say over using or abusing either. I put it up for the day, and when I went to use it the next, it simply

...plasma cutter wont cut on cars Like an other welding job - be sure the grounds are clean and secure. Ground as close to cut as practical and if trying to cut painted area - remove paint for good ...

mishto ct 312 plasma cutter wont cut did work !but no only op speraticly & not prop! thinking maybe earth problem not only earth problem, change electrode, nozzle and cathode

plasma cutter wont cut not cutting properly good consistant pressure 35 psi cutting capacity pressure minimum 5 bar