Questions & Answers for: pipe clamp

Ad

Question about ATF6000ES Front Load Washer

1 Answer

...down you will have to add a 1/2 inch pipe ,about 5 inches is long enough.Use the pipe to clamp your hose to with adjustable clamps not Spring clamps.The pipe serves as a union here. Please rate this

Ad

Question about 1995 Camaro

1 Answer

...pipe clamp screw and the hose pipe clamp. Clamp off the heater hoses. Fig. 1: Heater hose and pipe routing-3.4L engine Fig. 2: Heater hose and pipe routing-3.8L engine Fig. 3: Heater hose and pipe ...

Ad

...clamp to the bracket on the water bypass pipe. Install the water bypass pipe with the bolt. Torque: 18 N.m (185 kgf.cm, 13 ft.lbf) 3.INSTALL REAR WATER BYPASS JOINT 4.INSTALL INTAKE MANIFOLD ASSEMBLY ...

...clamp on each hose; (3)slip the piece of pipe into both hose ends to connect the two hoses together; (4)install and tighten clamps on each end of hoses over pipe. (You might want to put a little ...

...weld and the shield rattles on the pipe easy repair use a hose clamp open the hose clamp up put the clamp around the pipe reconnect the hose clamp slide it over the heat shield and tighten the clamp ...

Question about 2006 G6

1 Answer

...pipe clamp hasnt been put back on ,so the o ring will still be their on the pipe ,now what i often do as a temporary fisx is couple of plastic ties to hold it back into position and a more permanant ...

...pipe. Assuming your clamp bolts will loosen. Loosen bolts on the doughnuts clamp. remove the clamp. Then pry the tail pipe away from the manifold and remove the old dougnut gasket. Spray it down with ...

Question about AD6 Airdyne Upright Exercise Bike

2 Answers

...pipe into the pinch clamp. Tighten the clamp after installed. If the clamp is to narrow to allow it to slide over the pipe then loosen the bolt or remove it and spread the clamp apart a little then ...

Question about 2005 FLHTC - FLHTCI Electra Glide classic

1 Answer

clamp bolt to 60-96 in-lbs (6.8-10.8 Nm), tighten the two bolts with lockwashers, tighten the four TORCA clamps to 45-60 ft-lbs (61- 81 Nm) in the following order, crossover pipe to left side muffler,

Question about Tape Self-fusing Silicone Tape 2 Wide X 36 Roll Industrial Size Clear

1 Answer

...You are better off using a repair clamp. Measure the outside diameter of the pipe. Go to a local plumbing supply house and ask for a repair clamp that will fit the diameter of the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1482 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Brad Brown

Level 3 Expert

18626 Answers

Are you a Washing Machines Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...