Questions & Answers for: pip Cars & Trucks

...from the front fender apron. Measure the resistance between the ICM terminals as shown below: GID-PIP IN: should be greater than 500 ohms. PIP PWR-PIP IN: should be less than 2,000 ohms. PIP

what is a pip sensor and where is it on my 94 grand marquis? 4.6 v8 PIP (Profile Ignition Pick-up) Is what ford calls the pick-up coil in there distributors. But the 4.6 engine doesn't have a ...

...The test fails when the signal indicates that two successive erratic profile ignition pickup (PIP) pulses have occurred. Loose wires/connectors. Arcing secondary ignition components (coil,

on my power stering from the rack there are two little elbows that join a solid pip to a flexi pip is there any way of fixing the leak without changing the whole pip No. The hose carries very high ...

O2 sensor up stream Where is this o2sensor located o2 sensor is always located in your down pipping or headers just wait till car cools down feel your pipping and the only thing that u should feel is ...

...dies no apparent reason Not sure if you fixed your stall issues but....have you looked at the pip signal on your fox mustang? My 1987 mustang gt was doing the same thing it got to the point ...

no spark from new coil Sounds like the problem lies in the profile Ignition Pickup (PIP) i.e Crank Sensor or in the Ignition Control Module (ICM), once the ICM gets the PIP signal, it starts to switch

need to know how to replace the pip on a 91 ford ranger 3.0 i know where it is just wanted to know if i have to pull the whole distribitor to change it pip ?????

...The test fails when the signal indicates that two successive erratic profile ignition pickup (PIP) pulses have occurred. Loose wires/connectors. Arcing secondary ignition components (coil,

Would a bad PIP sensor cause no power or no noid at the fuel injectors on a 92 V6 Ford tempo with a Distributor? The car ran fine before no starts. Have spark, I have power to ICM, & distributor but ...