Thanks 1-Open tray 2-lift left side of roller ( it is spring loaded and should lift easily) 3-pinch rollers and remove 4- take out whole tray and look inside underneath to see pick-up and feed rollers
...stock would result in a paper jam. The card stock would start to feed, but then stop half way. The pinch rollers seemed to spin without advancing the paper, even if the paper was fed one sheet at a ...
pinch roller. I have tried various thicknees of paper, but no luck. I tried the laserjet cleaning paper but still no luck. Is there a way to adjust the pinch? Walter [email protected] You may need
...or so before stopping; hold and release several times and hope that one of the stops is between pinch rollers that will yield up its load of paper fibers. This is NOT a 'sure-fire' method but can ...
Question about Officejet 6310 All-In-One InkJet Printer
...It is not there when we scan and copy from the glass. Please advise...thanks. Need the clean the pinch rollers on the top of the unit. Use a small amout of alcohol on a piece of paper towel. Clean ...
...roller in tray 2. Pinch the blue latch that is on the left side of the roller. Slide the roller off of the shaft. Then you can slide the new roller back in. CAUTION When you install this roller, make ...
roller. Pinch that clip to take the roller out and clean with soap and water. do not use alcohol based cleaners, they dry the rubber up and shorten the life span drastically. The separation pad should
printer will not take up paper Clean or replace the rubber rollers,inside the back of paper transport area of the printer.You have to open up the printer to reach those pinch rollers.
...roller. 3 Pinch the tab on the end of the cassette pickup roller (callout 1), and pull the roller out. 4 Pinch the tab on the end of the cassette feed roller (callout 2), and pull the roller out. ...
Question about Officejet 100 L411a Mobile Inkjet Printer
...will not draw in the paper Had the same problem with my Officejet 100. The rubber rollers that pinch and grab the paper are dried out. i stuck my fingers into where the rollers pinch the paper ...
Usually answered in minutes!
2,817 Questions
2,162 Questions
1,869 Questions
1,584 Questions
1,504 Questions