Questions & Answers for: Chevrolet Blazer pin issue

...issue, check and make sure the transmission connector is ok, no broken locks on hard shell or bent pins. pumps have to match numbers, and yes, everything has to be right. Check the relays in your ...

...pin#. I checked the fuel pressure, its good and changed the coil and fuel sensor. Its making me crazy. Anyone that has had the issue or advice will be appreciated. Ken Have you checked for spark? If ...

...are two connectors on it one on each side - check for continuity on the connector that has two pins - that will be the pick up coil - if it reads OL on the meter the coil is bad and replace ...

...you. the big plug that goes into the fuse board clean it and put some vasaline on teh connecting ...

...issue as well. here is a quick starter test procedure that will help you troubleshoot a bit. Step 1 Check for 12 volts on the large wire attached to the top terminal on the starter relay. It should ...

...pin removed but the gear still won't slide off to remove the shaft to replace the pick-up stator tis is off of 1989 s-10 This can be an issue at times, especially with a higher mileage engine with ...

...issue with a 96 and replaced the whole CSFI spider assembly with a MFI spider assembly and problem was solved. try spraying a little starting fluid in the throttle body. If check it doesnt run take ...

replace door hinge pins? I suggest that the pins are only a part of the issue, wear is NOT limited to the pins. Tolerance will certainly be a little better with new pins, but REALLY, you need to ...

is the safety neutral switch connecter attatched to it or separate if if the switch was chainegd and not the connecter then could the connector be bad? this is for the 2001 chev blazer Hello! The ...

the driver side door on my 2002 chevy blazer wont close.how do i fix it? I opened the drivers side door on my blazer today and when i went to close it,it wouldnt close all the way.What do i do? Door ...