Questions & Answers for: picture of steering knuckle

...picture if a tire and in the middle says t/c The ABS and T/C lights come on periodically. ABS kicks in as though in panic mode when it shouldn't. The left hub sensor and knuckle were replaced already ...

Ad

...steering knuckle, simply scroll down/up list on right side & click on "knuckle" for further instructions. Click on pictures for expanded view. Good Luck ! ...

Ad

...steering knuckle so I can get to the four bolts that attach the hub unit to the steering knuckle. I am replacing the front rotors on a 91 Honda Accord. Can you send me some pictures? [email protected] ...

Question about 2003 PT Cruiser

1 Answer

...picture of what the steering knuckle looks like with the bearing in? Does the bearing push flush on the Knuckle? You'll have to take the hub to the shop and have the bearing pressed out and the new ...

...jack under A frame put a pri bar between ball joint and A frame,hit the steering knuckle with a small sledge hammer or use puller. remove shock lower A arm or raise truck to remove ...

...steering knuckle from the vehicle. However, if the hub/bearing assembly is frozen to the steering knuckle, removal of the steering knuckle is required. Disconnect the negative battery cable. Remove ...

...PICTURE OF WHAT THE COMPLETED INSTALLATION SHOULD LOOK LIKE? The steering shaft/Knuckle is a spline shaft very delicately machined, you have perhaps damaged one or more of those machined splines? so ...

steering column is loose at tilt knuckle General Motor cars will have this problem if you use the steering wheel as leverage to get in and out of the front seat. They use a ratcheting ball and socket ...

replace the steering knuckle.... then what you need to do is to ogo search on eBay for a repair manual. it will cost less than a tank of gas and will have all kinds of info, instructions, and pictures

Question about 1986 Corvette

2 Answers

...steering knuckle/spindle up and out of the way . then take a pry bar and pop the axle out of the trans housing. install by reverse procedure and make sure the axle locks into place in the trans ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...