Question about K45SS Classic Stand Mixer
...phase control board/speed control board on my KitchenAid Classic Stand Mixer (max watt 250) is stuck on the "10" speed and it will not budge. The mixer works fine, but I cannot use the speed/mixing ...
...10 - 280 Second, if the mixer won't run: Remove the Control Plate Assembly (36), the Phase Control Board (39) and the motor Governor Assembly (35). Inspect for loose connections, burnt or damaged ...
Question about KSM150PS Artisan Series Stand Mixer
10 and after 30 sec stops I thought it was the speed control pannel then I order one online and change it but that work 2 times and i have the original problem again .Please help In the Artisan mixers
Question about K5ADH 5 Quart Mixer Dough Hook Kitchen Aid
phase control board. i bet it fixes the problem as these are the two parts that regulate the electricity in the mixer. Hope that helps. Buy the way if you don't fix the problem and continue to use the
...10 Is speed lever literally stuck and can not be moved or is the motor speed always on high? The two have separate solutions. The easy one is the stuck lever. Open the mixer up and see what is going ...
10 are the same as speed 6. The mixer is also grinding and making clicking noises. How can I fix this? It sounds like two issues, the first is going to be the phase board, you will need to replace it,
...10 works The first thing you need to do is remove the end cover on the mixer, there is a screw at the top you need to undo then in an upwards motion you should be able to pull that off. behind there ...
Question about KSM75WH WhiteTilt-head Stand Mixer
10. Have you checked the carbon brushes? The phase board you have just done is normally the culprit for your problem. Ross has some good advice. The speed control mechanism is mechanical and relies on
...phase board and governor) to ensure that all parts work well together. When the new parts arrived I installed them, checked that all connections are correct and tried again to adjust the speed. There ...
...10 seconds.. Changed the control plate and the phase board and tried to adjust the screws and it stays the same! Help me please I don't have assistance in my country.. Sorry, that answer was for ...
Usually answered in minutes!
493 Questions
357 Questions
324 Questions
285 Questions
205 Questions