Questions & Answers for: Ingersoll phase 10

how long should it take to fill up 80 gal tank with a Ingersoll rand type 30 air compressors sizes 3 & 1 3/4 X 2 compressor No 30T356 it could take up to 30 minutes from zero pressure 10 to 13 ...

...can i pull off of a 120 receptical the nuetral and ground ( 12 guage) THE 220 is 10 guage. Thanks Um NO, It's only single phase. You need to get a suitable Amperage 220v - 120v step down

Air compressor IHE-10, Make Ingersoll Rand getting overload trip some times during operation. What are the possible causes. check for loose wires..is the overload set right..should be around ...

...10 HP motor at three phase. Do you have three phase at your location? If not I would look into getting a single phase compressor. If you do want to get it going I would notify your local IR dealer so ...

what RPM range to HP can be run on this pump, I'm building from scrach 5hp and 3450 rpm are the standards 1500 RPM is max the pump can run. the motor can be either an 1800 or 3600 RPM - sheave size ...

Need wiring diagram to wire pressure switch to magnetic starter. We have a 2545 E 10 V Ingersoll Rand Compressor 3 phase 7.5hp magnetic start wire schematic

I have a t30 I R that sometimes will not start,it kicks the breaker, can turn it manually and try again and it will start, are the capacitors bad, the compressor is about 10 years old.230 v 5 hp comp.

T-30 compressor will not start up without loading motor. How many check valves are there and where are they located. My unit has an aftercooler. Unless it is a duplex unit (2-compressors on one ...

10 min,then stoped again OK I am guessing this is a modular drive. Fault 39 is an IGBT fault on phase U and 40 is an IGBT fault on phase V. Unless you are experienced it's best to have a qualified

...10 hp 3 phase converted to single phase sometimes runs great. sometimes it stops compressing, goes to a straining free wheeling state. At that point we kill the power or it trips the breaker. Bought ...