Questions & Answers for: permanent storage unit hp

...Permanent Storage Init release the two buttons. When the process completes you will see the ready message. This will reset ALL menu settings. If you screwed up the firmware update, you will have to ...

...until you see permanent storage init). If this doesn't work call hp tech support 1800 334 5144 and ask for a case number. This printer has a service note which will cover the formatter for 2

...permanent storage init" This should clear that error message You must be using new hp original supplies otherwise the unit will not recognize the cartridge. Try checking with flash light if theres a ...

...permanent storage init. with both green ready & orange exclamation lights flashing & unit will not function HI, This a formatter failure, sounds like the formatter went out while ...

...cancel. Then turn it on and wait for the message ''permanent storage init'' then release the keys and will get back to ready. If the error persist contact HP because the unit need service. Good ...

...until you get the message "permanent storage init". Release the keys and hold until the unit get back to ready. It might ask you for language and location, just select with the arrows and press ...

...Permanent storage unit. Then release the buttons. Wait for about 2 min. When the printer is back at the ready screen it has been reset. Warning:it will reset EVERYTHING, including your serial number ...

...everything and left it that way for 30 min, then tried again. Same routine. Any help would be much appreciated. hi guys i did tha and it stay there by Permanent storage initand doesnt go ...

...permanent storage inti will appears on display & starts calibrate wait till ready mode comes. Switch off and again start,check.. I hope your problem will sort it out. If not resolved, color ...

...buttons at the same time while powering on printer. continue to hold down until the control panel display reads PERMANENT STORAGE UNIT. RELEASE BUTTONS. printer should return to ready ...