Questions & Answers for: Honda pcm wire

wire between VTEC pressure switch and PCM 31-pin connector "C" terminal No. 10. Repair as necessary. If wire is okay, substitute a known-good PCM and recheck. See SUBSTITUTING PCM in SELF-DIAGNOSTICS

...wire between the ECM/PCM (E15) and the ELD. 12. Check for continuity between ELD 3P connector terminal No. 2 and body ground. Is there continuity? YES - Go to step 13. NO - Repair open in the wire ...

wire from the PCM and then check for proper voltage at the PCM pin. If it's present now, repair short on the circuit. If it isn't present after removing the wire and checking the pin, replace PCM NOTE

...wire that fails between connector and sensor, if all tests are good then try a good pcm. i dont think its pcm, i think if its not a wire then replace sensor , but good luck and i hope this

...wire from the PCM connector 2. If the scan tool ECT reading seems normal at this time then the problem may be intermittent. Use a "wiggle" test to manipulate the wiring harness and connectors while ...

No power, find and fix the open circuit in the wire. If you have power, than the issue is either the ground wire going into the PCM, or the driver diode [inside the PCM] is bad and you need a new PCM

...- 7.5 Amp fuse in under the dash fuse/ relay box. - Repair open wire between 7.5 Amp fuse and ELD. - Check for open wire between ECM/ PCM and ELD. - Substitute a good-known ECM/ PCM and then

...wire between the ECM/PCM (B13 (B21)*) and the A/F sensor (Sensor 1), then go to step 15. Remove the jumper wire from the A/F sensor (Sensor 1) 8P connector, then reconnect ECM/PCM connector B (24P). ...

Not able to communicate with PCM with diagnostic scanner Alternator was bad, output 18v, changed it but now it's not charging system. Also has new battery. did you really check all fuses. (using an ...

...gears. I have swapped steering column immobilizer parts, keys, fobs, Instrument cluster, and PCM. The battery is new, the charging system operates within spec as designed. All associated