...to dry out, so mould collects in the door. When the washing machine isn't being used, I simply leave the door slightly open - the washing machine dries and the black mould issue just about
...patch underneath the washing machine and down the back of the outer drum, underneath the drum pulley (where the belt goes) although this patch is not always present. There are usually two small holes ...
...door gasket of a Hotpoint 9901w washer dryer. Is this easy to replace? It is quite involved to change the seal, as requires a partial strip down, if the hole is not very big, then you can do a fairly ...
...patch underneath the washing machine and down the back of the outer drum, underneath the drum pulley (where the belt goes) although this patch is not always present. There are usually two small holes ...
...washing machines are very heavy, an alternative way of replacing the door bellow is to remove the lower toe panel and tilt the washer back at a 45 degree angle instead of removing the washer front ...
...Machine is I think made by Whirlpool, google for spares/parts, there are many sellers. As a last ditch attempt if you don't want to spend much use a strong light and inspect carefully, you may find a ...
Question about HE2 Plus Front Load Washer
...machine each time. I thought it might be the drain but when I checked it there was only a bit of lint and a dime. Which leads me to believe that was not the problem.....any ideas? Hi, Very carefully ...
The grey rubber door seal on my LGWM2016CW has a crack and water leaks out on use - can I repair the crack myself? i replace one or two a day and havn't seen any descent patch jobs blu tacs the best.
...patch over the tear with contact glue (make sure both surfaces being glued are clean and buffed with a coarse abrasive) on the outside of the seal and then replace it with the repair towards the top. ...
...door and tank has a hole in it Need to replace your boot seal. If you do not what to go to that expense, if the hole is small you can use silicon sealer to patch the hole and let it set for at least ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions