Questions & Answers for: Epson paper pickup

...Paper pickup probably not working correcty. Best solution is: 1 Remove door E, It just bend the hinges and spring it out. 2. Remove the rear paper carriage unit. 4 screws, 2 obvious, 2 recessed. 3 ...

...paper, and vibrating the pickup "wheel" so it sounds like a mini jackhammer. I you reach in the tray area and manually push the pickup "wheel" around the extra little notch by hand, the paper goes ...

...the spring in the back side of the paper picker unit elangated to more thickness and fail to function fully. you can remove the paper pickup unit and change the spring if you have the service

...Or if you have experience in disasembling and asembling printer, you can repair by add thcikness pickup rubber and rearrrange position of the rubber. Also check lubrication of paper feeder

...the printer. Roller start to pull in the paper but one side is blocked causing to start to enter at an angle and the jamming after 1cm in. please clean the paper pickup roller and check paper ...

...paper goes in before it starts to twist to the side. Sometimes I've had to use a dental pick to snag a shred buried deep inside as an alternative to dismantling the printer. You may find it ...

...wont feed! (epson 830) Hi This looks to be a problem with the paper pickup roller. Hence use a little thin Photo paper or replace the Pickup roller and also the Paper feed toller (Long black roller

...paper pickup feed mechanism is at fault.  One of two methods is used to pick up the sheet.  Either the front lower portion of the tray is lifted up to force the top sheet into the feed ...

photo paper type settings but the printer picks up the paper and rolls it straight through without printing weather there is paper in the loading slot or not The paper pickup roller should be adjusted

to reload paper & hit OK button. Have done this numerous times, but cannot get paper feed to grab. The pickup roller has too much paper dust embedded in it. You can use alcohol and swabs to clean them