Questions & Answers for: Lexmark T paper jam error

...paper jam open rear door" will NOT clear. turned printer off several times. no luck. please advise. thanks usually it means that a sensor in your fuser is bad. If you have a P.M. Kit replaced the ...

paper jam Getting error message 242.10 paper jam, but there is no obvious paper jam. Our local technician could not find any problem. What should I try? Call me at 336-516-5070 I had the same problem ...

...Paper Jam and Check paper stock jamming. We have an issue with it giving us a Jam error, rear paper door with no apparent jam. We also can't run check stock through it without a jam after the second ...

paper jam in the back door. I can see the edge of the paper. How do I release the tension on the rollers so I can slide it out? Now it is in there tight and to grab it just tears off a piece of paper.

PAPER JAM ERROR 201.02 Does any one know how to clear 201.02 Paper Jam error? if you are gettiing a 201 error without any paper in the printer you will need change the main motor drive if it fails to ...

...paper jam error We cannot find any paper jammed in the paper hello, The paper jam error 242.13 can be caused by an actual paper jam in the printer but since you did not find any paper the next thing ...

Error message "Paper Jam Remove rear cover." No paper jam... Open the rear, there is one of the paper sensor actuators stuck. They are spring loaded and should spring back when pushed out by the paper

...PAPER JAM AND THERE ISNT ONE. DOESNT SEEM TO WANT OT PICK UP PAPER ok im going to guess here that you are getting a 201 paper jam error with no paper in the printer. this would indicate a bad main ...

...printer has a error message saying remove paper from standard output bin Paper is most likely jammed in the system. Take off the back or front panels, pull paper tray and remove jam. Reboot

...paper jam The 200 and 200.xx Paper Jam error messages indicate a problem with paper jammed at the front of the printer, under the toner cartridge. To resolve this issue, please refer to this article: ...