...panel, check to make sure none of the lock linkage is bent. If it is bent try bending it back. If its not bent pick up a can of white grease and spray all the moving parts inside your door that ...
...lock switch housing. On models with electric outside rear view mirrors, remove the power mirror switch housing. Remove the retaining screw and washer from the trim panel lower corner. Using a special ...
...panel on the dash click, and the lock posts twitch, but that's all it does. Also when I shift to drive, the doors won't lock. At the lock switches I am getting 12v on both sides which by the book is ...
Question about 2002 F150 Regular Cab
...that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need ...
panel, and apply DC power to the door lock directly. Polarity 1 direction is lock, the reverse polarity is unlock. IF the door lock still works the same with direct voltage as the door lock switch, it
...panel to bgain access to the lock cylinder,diconnect the lock rod and the large spring clip and remove and replace the lock assembly and after installation test operation before reinstalling the door ...
...panel, and check the lock actuator. If you want instructions on removing the door, I recommend using Muth Co's signal mirror install directions : www.kwmuth.com. Enter your make & MY, on the ...
Question about 1995 F150 Styleside Regular Cab
...lock tabs the hinge side also keep the panel in place. 3 clips are on the top of the panel where the window rubber is. Gently rock the panel to get these clips off the door, paying attention to the ...
panel to get the lock back into place A good place to get directions with pictures for the door panel removal is Muth Co. www.kwmuth.com Enter your Truck info, on the product page is a URL for the PDF
...lock the actuator is frozen, this is the actuator that locks and unlocks the door, when it goes bad it wont move and holds the linkage locked in that postion, you will need to remove the door panel ...
Usually answered in minutes!
2,636 Questions
1,214 Questions
1,298 Questions
1,160 Questions
1,038 Questions