Questions & Answers for: Chrysler Sebring panel lock

...Open the fuse box found on the far left side of the dash with the drivers door open. Remove the panel cover and you will see an unmarked fuse with what appears to be black fuse pullers attached

...panel is off, if any clips remain in the door, take them out and put them where they should be in the door cover it won't go back together properly if you don't. Now you'll need to pull down the ...

...you get the platic housing off? I didn't see any screws and I didn't want to break it. The plastic panel is held in place with self locking plastic inserts and two or three self tapping cross head ...

...10 Amp one but has black thing on it. Can't get if off.. Have read the manual is wrong and to use panel on side of fuse box for fuse

lock cylinder. Install the 2 combination switch mounting screws. Install the lower and upper shrouds. Install the knee bolster to the lower dashboard panel and tighten the lower knee bolster attaching

panel. Disconnect the lock and latch rods from the outside door handle and the key cylinder at the door latch. Disconnect the wire connector from the power door lock motor. Remove the screws attaching

...will not release the door. The outside door lever works fine. 1) How do I remove the inside door panel? Thanks, Larry See this link on the same site: ...

... there are wires to the power switchs and rods to the handle and door lock button so don't pull the panel away too far too fast. A plastic panel removal tool is helpful and inexpensive. hope this ...

...lock etc with the electric switches in the car and the remote. We brought it in to Chrysler dealer and they fixed it by resetting something but was not to specific. It happened again just out of the ...

...lock/unlock on the same side doesn't work either I have to unlock doors on the inside manually..All other windows work fine Sounds like a connector is disconnected inside the driver side door. The ...