...microwave oven. But it will stop in seconds. In most cases, this is a problem with the inverter or a bad magnetron. Due to the lethal voltages used and produced, I do not recommend that an ...
Question about NN-S753 Microwave Oven
Panasonic NN- A712 combination Microwave 1000w - Switches off after 20 seconds Hey, I hope you can help. My 5 year old:Panasonic NN- A712 combination Microwave 1000w works fine in all functions except
Microwave starts up for five seconds then stops,A louder than usual sound is heard as if a relay is clicking on count of every second before it comes to a stop. Panasonic NN S262SF over the oven mount
Panasonic microwave oven NN-L531WF. Countertop, 1100 Watts. It's 8 years old. Used about 5 times a day to heat water for a cup of coffee (60 seconds). Problem: All of a sudden, it runs only 3 seconds,
Question about NNSN657SAPH Microwave Oven
I have a 7 year old Panasonic over range microwave NN-S263WF which just started automatically shutting off after 5 seconds. Clock light remains lit - it just stops. Invertor faulty?
Question about NNSN657SAPH Microwave Oven
year old Panasonic over range microwave NN-S263WF which just started automatically shutting off after 5 seconds. Clock light remains lit - it just stops. I would check the magnetron and invertor board
Panasonic NN-H665BF starts and will run for about 5 seconds and then stops without heating up anything. Hi, Here is a tip that will help you to figure out what is wrong with yourMicrowave Oven.... ...
...Thanks for any pointers! Larry. We recommend you use the below link to locate an authorized service center. Panasonic microwaves have a 5 year warranty on the microwave. ...
Question about NN-S563 Microwave Oven
...Panasonic Microwave the Genius Prestige and when I set the time to cook it turns off in 9 seconds even though I set it for 50 seconds. what should I do? I already stated. When I set the time the ...
Question about NN-S563 Microwave Oven
My Panasonic genius 1300w microwave oven will heat for about 4 or 5 seconds and then cuts off. I was trying to heat something for 45 sec. and it stopped at 40 Could be a control board defect
Usually answered in minutes!
3,405 Questions
567 Questions
285 Questions
308 Questions
275 Questions