...loose connections. I tested for continuity for the door lock switch: P8(3) and the neutral and P1(1) and the neutral prong of the power cord. Instead of a constant buzzing sound of the voltmeter ...
Question about Neptune FAV6800AW Top Load Washer
...P1 Motor Control common P2 Torque (to Motor Controller) see page 1-11 MAH3000 P3 Motor Control Tach (to control board input) My WAG is replace the Motor Controller 1st, then Control board 2nd and a ...
Question about Neptune MDE5500AY Electric Dryer
Maytag 7500AYW electric dryer stopped working after a transformer blow up. The interior light works, but the LCD panel does not. I checked the voltage input (L1 L2 N) and they are fine. I get no ...
...control board by probing the back of pin 8 of connector P2 (White wire) to the back of connector P1 pin 8 (Red wire) You should read line voltage. You could also have a motorized damper problem ...
Question about Neptune FAV6800AW Top Load Washer
...But some pic's for ref; How to check that the magnetic reed relay is closing with you DVM. I'm on P1 and P2 of the left hand lid lock. Those pin are referenced to the schematic jut for my ...
...P1-4. If the resistance is between 1-6 ohms, replace the control board. If not check the belt switch for continuity. Check the motor windings at the motor switch. Disconnect the motor connector. ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions