Questions & Answers for: Hyundai Santa Fe p0335 ckp sensor


Sensor needs replaced. The CKP is what I replace the most for no spark on the 2.4 engine. It is behind the timing belt cover mounted above the crankshaft sprocket. Sometimes they just fail because the


...primary wire, bypassing the capacitor. Still no start. Code reads P0335 cranks shaft position sensor "A" circuit malfunction. IN OUR EVERT TO START THIS VEHICLE DID WE LOOK AT FUSES(ECU) OR FEUL ...


...CKP) sensor Removal & Installation Disconnect the negative battery cable. Disconnect the connector from the sensor. Remove the retaining bolts. Remove the sensor from its mounting. To install: ...

...sensor twice still get pending code p0335 no start fuel pump sounds like it is coming on dont think it is firing plugs is it in security mode somehow Hi Check the main relay in the engine ...

P0335 "check engine light" code could be caused by: * Damaged CKP sensor connector * Damaged reluctor ring (missing teeth or not turning due to sheared-off keyway) * Sensor output open * Sensor output

Question about 2004 Santa Fe

1 Answer

CKP) Sensor If the CKP has died completely there will be very high resistance between the device's electrical connections associated with the open circuit. Furthermore spark delivery to the plugs will

p0335 and said crankshaft position sensor a circuit malfunction .Book doesnt even show this code and Auto Zone couldn't find it on the computer. Any ideas or knowledge out there? P0335 is for a faulty

...sensor (CKP)/engine speed (RPM ) sensor---circuit malfunction====causes ---wiring---CKP/RPM sensor ---ECM code p 0340 refers to camshaft position sensor (CMP) sensor A bank 1---circuit ...

...sensor is located on my 2002 Hyundai Santa Fe 4.2L 4cyl.. 5sp.manual trans my car just died and wouldn't restart (OR TURN OVER). After doing a scan I found it had a p0335 code - I need to know who to ...

Question about 2002 Santa Fe

1 Answer

...CKP sensor was totally cooked and falling a part. So, I replaced both of them. The car also has a code for MAF sensor low voltage. I check for clogged air filter, cleaned the already impeccably clean ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides