Question about - EVD Projection Lamp for Overhead Projectors Multimedia Projector
...overhead projector that will not illuminate. Checked the 2 bulbs and fuse; all were clean and looked fine. The fan runs when I turn on the machine. this is my 3rd brand new apollo 3000 that is not ...
Question about 90 Series Open Head Overhead Projector
...overhead projectors, the Buhl 2900 can accept TWO projector bulbs (the operating one plus a spare). Make sure you inserted your replacement bulb in the slot for the operating lamp. There is a slide ...
my ally overhead projector wont turn on If the unit is completely "dead" look for power problem. Obvious - outlet and power cord breakage, then fuse.
...Overhead Projector. After about two months of use, my bulb stopped working, so I replaced it with a new bulb. When I turned on the projector, there was a slight "pop" and the bulb never lit ...
Question about 90 Series Open Head Overhead Projector
...overhead projector I have a 3M 1700 overhead projector and when I push the red on button, the projector turns on, but as soon as I let off of it, it turns off. So it will only stay on if there is ...
Question about Horizon 2 OpenHead Overhead Projector
...overhead projector it displays picture on the ceiling. Need to adjust to show on the wall. Do not have a manual. Hi! This is a pretty common problem with overhead projectors. At the top of the arm ...
How do I turn off the machine safely? I thought fan would stay on after light was turned off, but the lamp switch only dims the light, stays on with fan. Worried I'll burn out the lightbulb due to ...
Question about 1650 Overhead Projector
Why cant I turn the side knob to make the picture smaller there is a set screw that locks it
Question about 1800 Series Overhead Projectors—Product No. 15302910
The lights won't turn on We put in new bulbs, etc. Check and see if you have a reset button. Some do and some do not. See if you have power going to the wires Make sure your plug is working properly. ...
...overhead projectors. Perhaps you simply haven't turned the knob far enough? How far is the projector from the screen? If it's quite close, you need to turn the knob to raise the lens. If far away, ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions