Questions & Answers for: outboard motor flywheel move

...outboard that is locked up by air or some thing.I tryed to start the motor because i ran out of gas and i turned it over til the battery died i recharge the the battery and noe the flywheel will not ...

...flywheel area of the motor. When you move the throttle there should be movement of the stator to advance the spark. Check for binding wires or disconnected linkage. See if the spark is jumping strong ...

...outboard 50hp engine that will not start. The starter engages the flywheel but the the flywheel does not move. If you are saying the Flywheel is locked or Frozen then I imagine the starter Bendix was ...

...Outboard. The solenoid works but centrifical mechanism does not. Try spraying some CRC Light lubricant on the spiral where the pinion gear slides up and down. Can you turn the gear so it will move up ...

...OUTBOARD ENGINE REVS WHEN PUT IN REVERSE is that on the remote control lever ? if yes then adjust the throttle cable to push against the throttle stop on the engine end so when you select gears it ...

...move it by hand, need answer. remove spark plugs and you should be able to rotate the flywheel easy ! then try starter to spin over , if not then remove starter and check the brushes inside etc ! ...

flywheel? or what makes it return to idle (stop) position? There is almost always a direct steel bar or rod link joining those two together. They have a nylon snap ball and socket, or a pin and cotter

outboard model 70 70hp. TDC is at the 464 mark on the flywheel per the book. When I crank it at minimum throttle the timing only moves to right between the 464 and the max spark marks. Shouldn't it be

motor problems starter spins but will not engage flywheel The stater gear is thrown up by the quick spinning of the starter motor. It is on "ramps" that move it up. They can get corroded or gummed up.

...move away from the flywheel. This is gear that stops the 2003 from starting when in gear. If that is stuck or broken it may not be disengaged. It literally jams up against the flywheel.... Again this ...