Questions & Answers for: Konica Minolta bizhub can t open tray

...Open paper tray 3, remove paper, close tray, open then shut front door, load paper into tray 3 - hey presto!! If the fault comes back you could have paper stuck behind the tray or have a defective ...

...tray). It hasn't managed to lift the paper successfully. Open the tray, remove the paper, reset the machine (open/shut front door) then reload the paper and try again Hope that helps Regards ...

...open the tray and check the paper tray and checkthat the paper is loaded correctly pull all the paper out of the tray and check to see if any is folded or crumpled if the paper is ok it could be the ...

Tray will open automatically. 2-If the 3rd large tray cabinet is not opening then turn around the machine, at the back side of the 3rd tray, you will see a small hole downside at the back of the tray.

...Open the tray and make sure the paper is loaded correctly. The paper should be touched on all four sides by the tray or by adjustable guides. Open and close the front door with the tray out. Once the ...

...Open the tray and make sure the paper is loaded correctly. The paper should be touched on all four sides by the tray or by adjustable guides. Open and close the front door with the tray out. Once the ...

tray 2 open and inch or 2. Just use the other trays until repairs can be made. Good Luck and Thank You for using Fixya. You have to remove the paper behind the traythen turn on and off the machinethen

...gear.Remove the misfed paper and push in the tray ,open and closed the right door and the copier must be ready. C 0204 - 2nd tray C 0206 - 3 rd tray C 0208 - 4th tray C 0211 - bypass tray Good

TRAY 1 WON'T OPEN AFTER LOADING PAPER I was loading paper into the tray and when i went to print it came up with an error code (which has now disappeared so i don't know what it was) Now the tray will

bizhub 552 bypass tray gives open error message while powering up is the bypass tray open???? please show the screen