...OPEN WITH KEY OR POWER LOCK (RELEASE BUTTON). CHECKED FUSE AND ITS OK. You may want to just remove fuze #28 under the hood...for about 30 seconds...reboots the bcm and it corrected my Aztek's ills. ...
...will be some plastic sheeting behind it that is stuck to the door itself....cut a hole in it.... Do your maintenance and tape the plastic closed. Installation is in reverse order. Just take your
...aztec driver door handle ( exterior ) , there is a lever ( push rod ) that goes down to the door opener, inside the door frame, that is connected with a little plastic threaded piece to the actual ...
door. ?Open the HVAC module assembly access door ?Remove the RH passenger compartment air filter from the HVAC module. ?Slide the LH passenger compartment air filter to the HVAC module opening. Remove
...Open the glove box door and remove its contents. You will see a door in the back. Deflect the lever and gently pull out at the same time. This will expose the filters. There are two of them so take ...
...inside or out and just clicks . the door latch has jammed or is stuck either way the door panel has to be removed the seat has to be moved so you can work its a hard job to open a stuck
...Usually a sign the blend door under the dash is stuck or the motor that controls it has failed.If you look up "blend door motor" on the auto parts stores websites you can get a picture of
...door would not open. I had someone lift up the handle outside when I again shifted the rods and the door opened only slightly but it is still firmly latched in the assembly. What can I do to get it ...
Question about 2003 Aztek
door is open Is there a door ajar light on? How about a seatbelt light on? These will cause the chime to sound. Possible door switch causing issue. You can unplug the chime module from under the dash.
Usually answered in minutes!
917 Questions
342 Questions
278 Questions
263 Questions
123 Questions
