Questions & Answers for: Kenmore one heat

...heat relay it will be the one with 2 large red wires.. a quick ck would be to unplug power remove the red wires and tape bear ends together pug back up turn on dryer if it heats unplug and exchange ...

Ad

Question about 62602 Electric Dryer

1 Answer

one meter probe going to the metal frame of the unit. You should get no reading. If you do the element is shorted and would have likely tripped your house breaker. Better to test a heating element for

Ad

Question about 62602 Electric Dryer

1 Answer

...110. If a fuse or breaker is blown on one side it can cause not to heat. One side of 220 is for the heating element, and one side is the for motor. Finally it can be the heaing sensor that is

Question about 96422 / 96424 / 96429 Electric Kitchen Range

1 Answer

...heat up. similar issue as a previous post. I was heating one of the heating elements on the countertop. I heard a pop and reset the breakers. Now the time is on but oven or counter top wont heat up. ...

Question about 62602 Electric Dryer

1 Answer

...heat is not always an element. It could be the thermal fuse (check this first), a thermostat or a leg of your 240VAC missing. Replacing an element is relatively easy depending on ones mechanical ...

Question about Elite HE4 Electric Dryer

1 Answer

...doesn't dry very well now. it's 5 years old now. its likley to be one of your heaters has burned out, it has two one for low heat one for high heat on low only one works,,, both work for high ...

...are clean. next shut off electric and check heat element for broken element. then get model # and serial # order and change thermocutoffs located on heater box and fanhousing ck these steps one by ...

Question about 73952 Gas Dryer

1 Answer

...should i check first and what readings should i be getting could be the heating element cant check with meter have to open her up and see if one of the heat coils is bad a new one will cost around

Question about 62622 Electric Dryer

1 Answer

...one of the 2 Circuit Breakers will trip. (<-reasons unknown) The motor will run but it WILL NOT HEAT. Try resetting the CB by physically pushing the breaker to OFF and then back on. Then run the ...

Question about 62622 Electric Dryer

1 Answer

...heat up Check the Circuit Breaker. It is a double Breaker Switch. one side is for the heat one for the motor. If that is good then it's possibly the Heating Element or one of the two heat

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Kenmore Dryer Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Brad Brown

Level 3 Expert

19187 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Kenmore Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...