Question about 1995 Ninety Eight
i have a 95 olds 98 new tps sensor put in still problems what can i had a new tps sensor put in my 95 olds 98 still wont stop giving me problems what can this be the tps sensor on the dash will come ...
...98. Thanks Art hi art , i think they are going to call it ride height in the alignment specs . front ride height would be 9.0" - 9.8" and that point of measurement would be taken at the rocker panel ...
...98 oldsmobile intruige When torqueing bolts on manifolds or heads you always start in the middle or center and torque in a circle motion and olny torque 1 bolt at a time. Start with a low toque and ...
...specs, recently purchased a olds 98 with a 455engine and single point distributor, point gap was at 19 the timing was at 10 and the plug gap was 35, the car doesent run all that well, so i did some ...
98 olds silhouette started sputtering computer read a code for oxygen sensor replaced both sensors and fuel filter but still running eratic some time dont want to run at all what are most commin ...
Question about 1998 Silhouette
oldsmobile 98 regency brougham what are the torque specs for the valve cover and oil pan? on the valve cover with that metel pipe was is tha call and is there a rubber gromment foe it that goes inside
Question about 1998 Silhouette
...oldsmobile 98 regency brougham The torque specification for the valve cover on a 1988 Oldsmobile 98 Regency Brougham is likely to be around 15-20 ft-lbs (20-27 Nm). However, it is always best to ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions