Questions & Answers for: oil pressure light 2004 sebring

Question about 2004 Sebring

3 Answers

...Oil pressure was measured at full spec, both at idel and running. may be just at the low limit. when the inertia sloshes oil forward the sensor can no longer "see oil" and reports it as low. Check at ...

Ad

...oil pressure sensor (switch) was the culprit. Several web references that I checked mention that the original sensors have issues with oil leakage, which eventually causes it to fail. The sensor ...

Ad

...be about 550 rpms in gear at operating temp. is you oil light coming on? if the idle speed is at the correct rpm and the light comes on, you either need a new oil switch or you have low oil ...

Question about 2004 Sebring

1 Answer

...rpm? your revs are too low. The engine speed drives the oil pump via the timing belt. too low revs = poor pump speed = low pressure. I'll bet when you rev the idle speed faster, the warning goes

The oil light is on but when I push the gas disapear and the oil level is ok. low oil pressure ?? could be anything from a faulty pressure swotch to a oil pump to a worn crankshaft

...be the problem, and how can i fix it? Sounds like bad oil pressure switch. Is the engine making any loud noise(s)? I'd replace oil pressure switch and/or check connection at oil pressure

Question about 2004 Sebring

1 Answer

...oil pressure sensor, icv, crank sensor , camshaft sensor egr, WHAT COULD IT BE! please help1 hi there.... first get the spark plugs checked. if the plugs have problems, there would be no check engine ...

...oil pressure light comes on in my 2004 Chrysler Sebring My oil pressure light will come on after the car has warmed up but only when the rpm is less than 1000, when it isidle, or sitting still. ...

...oil pressure sensor switch first off if the oil warning light is on, u need to check the oil pressure with a gauge with the engine at operating temp. and make sure oil pressure is up to spec. a bad ...

oil pressure is at an absolute minimum. Check the oil level in your crankcase, and top it up if necessary. If you still get the light coming on, you may have a bad oil pump, excessive wear on bearings

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...