Question about 13,000 Watt / 13,000 Watt Home Standby Generator
...oil fill hole. Remove this wire and try to start the generator. If it runs without a problem then it is the switch. You need to remove the switch and take it apart carefully and clean it. There is a ...
Question about 5626 GP Series GP7000E 8,750 Watt 410cc OHV Portable Gas Powered Ge
Just purchased the GP7000E. Filled it with the oil and Gas. Attempted to start and the electric start just spins, does not engage the engine. Gasoline pours out of the face of the fuel valve when open
Question about Generator 5989 2,700 PSI 2.3 GPM Gas Pressure Washer
...pump for a generac pressure washer model # 01676? Check and see if there is a sight glass on the side of the pump. If there is, just fill it until the oil shows up about half way in the sight
Question about 5622R GP5000 GP Series 5000 Watt Portable Generator
...fill with a couple gallons if fresh fuel from a fueling station. If it still needs partial choke to run with fresh fuel then the carburetor needs a thorough cleaning. If it runs fine with partial ...
Question about Generator 5989 2,700 PSI 2.3 GPM Gas Pressure Washer
...OIL FILL YOU BE ABLE TO TOUCH HE OIL THERE IS ALSO A SLIT INSIDE THE OIL FILL INSIDE OF OIL FILL .FILL THE OIL FILL TO THE POINT THAT THA IT COVERS THE TOP THE SLIT BUT DONT OVER FILL THE MOTOR THE ...
Question about Generator 5989 2,700 PSI 2.3 GPM Gas Pressure Washer
...in the manual to indicate how much oil to put in. the only thing i can suggest put your pressure washer on level surface and start fill the oil when gets to the right level the oil start coming ...
...OIL WITH 30 W OIL FOR SUMMER USE I HAVE A 10W 30 ALSO THIS WEIGH IS FOR SUMMER USE. USE A LIGHTER WEIGH OIL FOR WINTER USE.PLEASE TAKE OIL TO A RECYCLE PLACE . ALSO DONT OVER FILL THE MOTOR WITH
Question about Generator 5989 2,700 PSI 2.3 GPM Gas Pressure Washer
...fuel tap under the tank they corrode internally and block the flow to the catby It might be the Low Oil Shutdown. Be sure the oil is filled to the top of the dipstick, and try running it again. If it ...
Usually answered in minutes!
58 Questions