Questions & Answers for: oil blow-by tube

Question about 1995 Cherokee

1 Answer

...oil pump? Can this be remedied by an averge DIYer on a limited budget? a fairly common problem on any of those high mile or abused 4.0liter engine either #1 your PCV ventilation tubes are plugged ...

Ad

...blow oil through it when the engine is run hard. Make sure you're not over filling the engine with oil when you change it because this will cause the oil to "blow off" the excess and the air box is ...

Ad

Question about 4 Cycle Blower/Vac

1 Answer

...oil to blow out a tube on the carb side. I drained all the oil out and refilled it with 5W 30 oil to the proper amount. It started first pull but the new oil is blowing out this same tube. Checking ...

Question about Bilt, Tuffy, Rear - Tine Tiller, 4.0 Tecumseh Engine

1 Answer

oil blows out of tube i have a 8 hp tecumseh snow blower when running at full power it blows crank oil out of a breather tube next to carb any ideas You either have a head gasket going bad or your ...

...oil. could be the carbs flooding filling your crankcase with fuel? if not it sounds like you have blow by which would cause your crank case to be slightly pressured. this is caused by worn piston ...

Question about 1978 Bonneville

1 Answer

...oil up the blow by tube and in to the breather. I have put rislone in the oil to help reseal the rings, and checked/changed the pcv valve. Now there is a thick caramel color that is in the blow by ...

...blow by could also cause oil to get into this tube. The blow by is usually caused by worn piston rings or valve guides. The compressed air/fuel mixture or exhaust pushes past these areas and make it ...

i have a lot of oil blowing out the over flow tube it will blow all of it out its a new 04 rmz 250 sounds like you may have broken rings and it pressurised the sump and blowing the oil up the tube

Question about 2004 RM-Z 250

1 Answer

...that be the cause of oil spitting out of my crankcase vent tube when I turn engine off? I'd quicker think piston ring blow by the piston thus compression leaking / blowing into the engines

...oil". 5. Crankshaft seal failure allowing transmission fluid to migrate. 6. Blow by drain tube cracked/split or filled to capacity. For more information about your question and valuable "FREE" ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...