Questions & Answers for: Yamaha XJ 650 ohm spec ignition wires

Question about 1983 XJ 650

1 Answer

Fuel Fump I have bought a 198 Seca 650 Turbo, and had to get a new fuel pump. Come to find out that there is no power coming to it. Where do I go to re wire it in? hey ,,u might have a corroded wire,,

Ad

Question about 1980 XJ 650

1 Answer

...plastic tab; the stator could be checked for continuity. Each yellow wire should measure 0.3 ~ 0.5 ohms to the next yellow wire at any yellow to yellow pairing; in most instances, the yellow wires ...

Ad

Question about 1981 XJ 650

1 Answer

Ignition I had a bad motor, found a replacement a lot cheeper than rebuilding origional motor. The original motor ran, swaped only the motor and generator stator. I have no spark at the plugs. I ohmed

wiring diagrams for a ignition module on a yamaha yics Hi and welcome to FixYa, The post is under an 81 Yamaha XJ650 and the need is for the wiring diagram (of the ignition module). Should you be ...

...ohm meter set it to DC,and red to positive black to negative on the battery start the engine and rev the engine watch the meter voltage should rise 13.5 if not check the stator for shorted to ground ...

I tried using quick start on it, but all that did was make it sputter a bit, so I am assuming that the fuel is not reaching the cylinders, anyone have any ideas? 1) Check for spark remove one of the ...

..."INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary. 4. Loose connection at ignition coil or plug between ignition sensor and ...

ohm meter, took the tank off to check the fuel pump and that seems to work when I put 12 volts across it. The next step I will check to see if I got a spark has anyone seen this? Are there other fuses

Question about 1981 XJ 650

0 Answer

ignition wiring coil wire Hi, Anonymous for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere $0

Question about 1982 XJ 650

0 Answer

...ignition switch in the on position, the kill switch in the run position, the starter button depressed, starter engagement should not bring voltage below 8-9 volts. If a lower voltage is produced a ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...