Questions & Answers for: Harley Davidson FLSTC Heritage Softail Classic ohm spec ignition wires

...ignition" circuit breaker. Voltage for this circuit breaker comes straight from the switch. I think the circuit breakers are under the seat. I have seen the coils go bad. Using an ohm meter, test the ...

I put a faring on my Harley heritage softail and want to wire the radio hot wire to the ignition switch. Is there a wiring harness available? I don't want to run the hot wire to battery and forget to ...

...ohm meter to check the primary side of the coil. Disconnect the small wires on the coil and put your meter in OHMS, R X 1 scale. Put one probe on each terminal of primary winding of the coil. It ...

wires could it be stator? Hi Anonymous, perform the following tests: 1. Fill acid type batteries to proper levels. 2. Charge battery overnight at 1-2 amps you need 12 volts or better after charging. 3

...wires. But as the bike is running I can physically see the ignition wire getting so hot it's melting on the end where it would be connected to the ignition switch Why has the fuse not blown? If the ...

ohm meter and they test within spec. I have also tried new spark plugs. Looks like the ignition module or crank position sensor. Some carb models also have a cam position sensor. Get the trouble codes

...ignition key switch OFF, then disconnect the voltage regulator connector from alternator stator wiring. THEN connect an ohmmeter set on the RX1 scale with one lead into either of the stator sockets ...

wires because you will also be reading the ohmmeter internal resistance and/or the wire and lead resistance added to the primary wiring resistance. You can also test the coil by leaving the "hot" wire

...ignition key switch OFF, then disconnect the voltage regulator connector from alternator stator wiring. THEN connect an ohmmeter set on the RX1 scale with one lead into either of the stator sockets ...

2004 harley flstc ignition goes on even when ignition is switched to accessories hi my harley led fuel gauge and i noticed it was resetting alot then i switched the bike off and turned ignition onto ...