...ignition cyl has to be replaced or the passlock sensor must be bypassed. You can use a 2300-4000 Ohm resistor and connect it to the Yellow and Black wires coming from the Car's wiring harness to the ...
...Ignition coils are a common problem with these. To verify, swap a couple coils and see if the miss moves to different cylinders. Don't change firing order, put the wires in the same location as they ...
...ignition wires and test the coil resistances. 3 coils test between each coil where the ignition wires go KEY OFF, they should be 5 to 6 thousand ohms each if not replace the bad coil.. also did you ...
...ignition key with an ohm meter. Purchase a resistor of the same value at Radio Schack and wire that into your ignition lock cylinder wire harness. You will find this harness near the base of the ...
...ignition switch to the left of where the stereo was. Look for a 3 wire harness that has a black, yellow, and white wire. You will need to cut the black and yellow wires and solder a resistor (1/8 W, ...
...spec, resulting in a false resistance reading. There are two solutions: replace the ignition cylinder, which is somewhat expensive, or drop down the glovebox to access the theft module and put a 2000 ...
...ignition switch or or drop down glove box to access anti theft module. and put a 2000 ohm resistor in line with wire to the modules input feed. the resistor is only 15 cents at radio shack and is not ...
...ohm meter(i think its 12-15ohms),if it falls with in spec then you could have a dirty or plugged injector.if the voltage is not good then you need to check the wiring from the computer to the ...
Question about 2001 Grand Am SE
i have a 2001 pontiac grand am se and turns over but wont start. whats the problem Check your fuel pressure and if its not within the specs replace fuel filter and pump.If its within the specs then ...
Usually answered in minutes!
1,771 Questions
1,538 Questions
1,504 Questions
1,435 Questions
1,208 Questions