Questions & Answers for: Dodge Ramcharger ohm spec ignition wires

Question about 1989 Ramcharger

1 Answer

...my 89 ramcharger gas and it starts to back fire and chug i just replaced the fuel regulater does anyone know wats wrong and how to fix it fuel pump, bad spark pluck, bad plug wire, ignition wires ...

Ad

Question about 1989 Ramcharger

1 Answer

what is the timing set at for a 1983 dodge 318/automatic? the sticker under the hood is gone. Hello snowcat426a:Not knowing for sure thing like altitude or if Calif. emissions here are all the specs. ...

Ad

What would make the ignition coil continue to short out on a 1987 dodge ram 150 le ? Thanks ! a short in the wire somewhere. check and make sure the wires aren't touching any metal.

...wires plugs and i have tested into the system as far as i can understand i also changed the ballast resistor the only thing i even know of left that isnt new is the ecu or ecm please help also what ...

...but no spark coming out, the entire distributor assembly, the starter relay, and even checked the ohms reading from the ignition module, yet there is still no fire reaching the engine. if anyone

Question about 1987 Ramcharger

1 Answer

i tried fixingMy 87 ramcharger but it ran great after I reconnected the ground wire and the ignition rod connects to the steering collom but it wirked great then it wouldn't start I believe its the ...

Question about 1984 Ramcharger

1 Answer

wires. The green wire goes to the alternator field circuit. The other field circuit wire gets ignition on voltage as does the center terminal on the regulator, either a red or blue wire, probably blue

...wires off-the wire going to the distributor would be the negative side, and the wire from ignition switch is the positive side. There should be a + sign, and a - sign on each side of the coil case ...

Question about 1990 Ramcharger

1 Answer

wiring diagram A/C heater blower motor not working. Fuse is ok. But there is no power going to he fuse. In cavity 1, the 30 amp fuse has no power with key on? A wiring diagram shows that fuse gets ...

...ohm meter to see if it is out of specs. The primary (- & + terminals) usually run .4 to 2 ohms. The secondary (- & coil tower) usually run 6K to 15 K Ohms. Where can I find a ignition coil ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...