Questions & Answers for: Buick ohm spec ignition wires

Question about 1996 Regal Olympic Gold

1 Answer

Ignition - Key seems to not connect when turning to start had this problem with my 1996 buick regal. the vats ( vehical anti theft system) wire broke in my steering column. you can dissasemble the ...

Ad

...are a little loose. Black wire is negative The other two wires are Positive. You can set this TPS fairly easy with the ignition on. The ohm meter will come with instructions how to use when ...

Ad

...ohm------wire 6. Measure the resistance across the 2 wires now that the resistors are soldered to them. Be absolutely sure the value matches that of the resistor pellet in the ignition key (within 2% ...

...ignition module. this is under the 3 coils they sit on the ign module..You can also test and or replace the spark plug wires, if a wire is 10 inches long it should read 10,000 ohms or less.. No more ...

...spec for the coils are 5000 to7000 ohms, measured between each coil from tower to tower (ie) #1and#4 2+5 and 3+6 any more than that and the coils are toasted..lol hope this helps also check the spark ...

...wires for excessive resistance with an Ohmmeter at each end, spec is no more than 1000 ohms per inch of wire, as well as checking the connections... the coils from tower to tower on each coil should ...

ignition coil. You can also dissconnect the connector from the coil and ohm the coil to make sure that the resistance is within manufacturers specifications. If it is not within specs then replace it.

..." images" section of google lots of things pop up,good luck,Gary I have a buick regale 96 and need ohms for ignition to get right key or find resistors to bypass vats all ...

...ignition wires with a light mist of water may help locate an intermittent problem. Ignition components will arc to ground when a secondary component is malfunctioning. - Defective module. - Ignition ...

...and terminal D. Turn the ignition switch to the RUN position. Set the tester resistance dials to 40 ohms (EMPTY). Set the tester resistance dials to 248 ohms (FULL). Does the fuel gauge display E at ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Buick LeSabre
2000 Buick LeSabre

1,731 Questions

1997 Buick LeSabre
1997 Buick LeSabre

1,603 Questions

1995 Buick LeSabre
1995 Buick LeSabre

1,084 Questions

2002 Buick Rendezvous
2002 Buick Rendezvous

1,091 Questions

1994 Buick LeSabre
1994 Buick LeSabre

904 Questions

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...