Question about Zoeller Electrical Supplies
...off when the float switch goes down The pump works but it is always on, and does not respond to the float switch that is connected to the top of the pump. Good Morning - I had the same problem with a ...
Question about 10-0034 Switch-Mate Pump Float Switch with 15' Cord
...switch to automatically top off the water in my fishtank. the best method I can suggest for testing the unit is to get an extension cord that you are comfortable with cutting. Cut one of ...
Question about 10-1044 Single Phase Duplex Control Panel with 20' Float Switch
...off about 1 pm, but the light did not come on. Tried to turn pump on maunually on the control board to Hand switch, nothing. Checked both fuses for Alarm Power and Pump Power, they appear to be fine. ...
Question about M53 Mighty Mate Iron Body, Poly Base Automatic Sump Pump 1/3 HP
switch unit off when in down position. Is there a fix or is it time for new pump? Can you replace the switch? If not, you can wire in a new generic float switch for far less than purchasing a new pump
Question about M53 Mighty Mate Iron Body, Poly Base Automatic Sump Pump 1/3 HP
off switch attached to the float switch is faulty. when the float drops, the switch should be activated with the float going down. Check the sensor to this which goes to the control unit. If the drive
Question about M53 Mighty Mate Iron Body, Poly Base Automatic Sump Pump 1/3 HP
must be adjusted to shut the pump off when no water is being used. If all water outlets are closed, adjust the switch to shut off. In most cases, the switch has instructions on the inside of the cover
Question about M53 Mighty Mate Iron Body, Poly Base Automatic Sump Pump 1/3 HP
...switch arm, but will not trip it to turn on the pump. If I barely bump or touch the arm manually, the pump kicks on and pumps water just fine. Ugh. Me too! I keeps setting off my back up pump with ...
Question about M211 Automatic Aqua-Mate Submersible Sewage/Dewatering Pump
...off even when water level is down. the float switch is getting hung up,first try to clean off the float switch ,shkae it like a rattle you should here it move inside, if that does not work relace ...
Question about M211 Automatic Aqua-Mate Submersible Sewage/Dewatering Pump
...switch is still off. If I by-pass the pump switch the and plug the pump directly into the AC outlet, the pump workd fine. Is the a reset on the pump switch? Check the connections between the switch ...
...switch may be stuck in the OFF position. Giggle the float arm up and down several times to see if the pump comes on.> You can spry wd40 into the switch where the arm enters. If this does not work, ...
Usually answered in minutes!
3 Questions
