Questions & Answers for: Ryobi on off switch

...off rocker switch and it has worked fine ever since. After digging thoroughly, I've found out that my local Bunnings (Australia!) is able to order it for me through their special order desk! $11.03! ...

...going to the switch (switch off). If so turn switch on and check for current coming out of the switch. If yes check for power at the motor end of the same wire. if yes chances are the motor is

...OFF WITH THE SWITCH. PULLED OUT THE SAFETY KEY AND PUT IT BACK IN BUT STILL WON'T SHUT OFF WITH OUT UNPLUGGING IT. CAN I ORDER A NEW SWITCH? THANKS BRUCE EDWARDS EDGEWATER, FLORIDA I KEEP TYPING IN ...

...off unless it is unplugged....any ideas Check yhe switch it may have dirt in it or be bad. But the switch is the first place to check. Relace the switch. I am presuming the lock button has not been ...

...a second wire will leave switch to a ground on motor. So it either came off module or the ground on the motor. Unit should run normally but would not be able to shut it off with wires

...it in The on/off switch is stuck in the "locked on" position or there is a short at the switch. In either case this presents a real hazard and should be repaired by a qualified repair tech. ...

switch it off via the ON/OFF switch nothing happens, machine still runs. ON/OFF switch tested as OK, it switches to earth, what is wrong the on off switch is stuck in the on position inside the actual

...switch from choke to run it shuts off. I have a Ryobi 780r that won't run unless it is on choke. The moment I remove the switch from choke to run it shuts off. This means you have an air leak ...

how to repair angle grinder trigger switch switch does not work The switches I have seen can not be repaired but replaced.

...switch will show zero ohms when push in the off position. This is opposite of what you normally being look for a switch in the off position but the switch grounds the ignition coil to kill the