...sit for at least an hour. that should reset everything. as far as reading codes you would need a scanner. on OBD-1 cars you could use a paper clip and flash the codes. but on OBD-II you need a ...
...OBD scanner. The scanner comes back with "PASSED NO CODES FOUND". The engine runs fine. it has happened 3 x in 10 days. I have had the light erased twice, but now its on again. The car needs to be ...
check engine light is on , how do i get it to show codes try finding free video instructions on www.vehix411.com you need a obd 2 scanner. your local auto parts store should carry it.
...what is wrong with your system. let me know the count and I will help you decipher the code. The OBD scanners that parts stores use wont read the ABS system. My past experience is taking it to te ...
...OBD II scanner to your vehicle and erase the code. If it comes back again after you erase it than either the original problem still exists or you have a new problem. You can go to your local AutoZone ...
...and put on a new battery. What can be a problem? Follow the wires from the alternator there could be a bad connectio. Do you have a obd-2 scanner or take it to a local Autozone they check it fro
...OBD Scanner on Pre 1995 cars? http://schematicsdiagram.blogspot.com/2011/12/how-to-get-diagnostic-code-without-obd.html ------------ OBD-II Trouble Code P0300? ...
...OBD 2 scanner at a local part store for about $35,(princess auto) plug it into the OBD 2 port under the dash (driver side) turn the key to the run position without starting the engine.It ...
...is the obd port to connect obd 2 scanner to Just need location It should be under the dash located under the steering wheel, approximately centered. It may or not have a cover protecting the
how to reset obd code in 2003 satern vue reset obd codes The best get OBD scanner or go to Auto zone they can do and you will know whats wrong.
Usually answered in minutes!
1,183 Questions
693 Questions
496 Questions
452 Questions
367 Questions