Questions & Answers for: Kia o2 sensor

...O2 sensor what it means is that the sensor does not react as quickly as it should and it needs to be replaced. nox is oxides of nitrogen, a product of too lean combustion which causes cylinder temps ...

O2 sensor faults I pressure washed my engine and it was running rough afterwards. That has cleared up but I now have check engine light with O2 sensor faults. To be specific: P0057, P0156 and P0158. I

...sensor/ O2 sensor 04 kia rio need to replace knock sensor/ O2 sensor, dont know location or degree of difficulty IT IS IN THE SIDE OF THE ENGINE BLOCK, SCREWED INTO THE WATER JACKET OF THE BLOCK O2 ...

O2 sensor Check the wiring to the sensor. An exhaust leak could also cause these codes to set Any of the following issues can cause the codes to set Most likely is a bad connection or faulty O2 sensor

...o2 sensor located in 2005 kia sportage? check engine light came on downstream left o2 sensor is bad. I have the replacement, but am not sure where the sensor is located. For oxygen sensor location ...

...O2 sensor replaced but still reading error. I am trying to get my Kia Sportage smogged. The error that popped up was the 2 O2 sensors. I had both replaced according to the code, the exhaust checked ...

...o2 sensor, erased the code, however the code came back. I suspect a short or open. Also at the same time code P0140 for bank one sensor 2. Also replaced that o2 sensor, cleared the code however the ...

o2 sensor has small dent thinking it may be bad, but will it keep air cond from working To clarify, none of this has anything to do with your a/c. Code 650 is for a problem with the check engine light

o2 sensor location The O2 sensor is in the exhaust system just of the engine and before the catalytic converter. Since some refer to the after cat converter sensor as an O2 sensor as well I would need

if not replace them. O2 sensor is located in the exhaust pipe between the motor and the catalytic converter. The front O2 sensor runs the engine and the after cat converter monitors the cat converter