...working. Maybe I hit them too hard but I'm not sure because the rest of my pads work. One will work if I hit it extremely hard but otherwise no. What can I do? Check the connections on the undersides ...
Question about JUNO-Gi 61-Key Mobile Synthesizer with Digital Recorder
working), then it is a problem with the internal electronics, and you'll likely need to replace some parts inside, or send it to a service center. Try www.syntaur.com for a parts source. If one output
works properly. Can you help me with my problem? Thanks Maxime Sorry, but this pedal takes a 9 VAC, not DC like many adapters. Pedal board power will not work with this unit
Question about BOSS BR 600 8 track portable digital recorder
Hi, I have a boss BR 600 and when i insert any card it checks the card and then says ' card not supported'. I t used o work fine. However i have noticed that 2 pins seem to be missing inside t
Buttons not working The buttons of my Roland sp 606 is not working the hold button and 3 more buttons... What can I do? open the back panel and clean the dust and close then turn on the sp 606
...not working I'm sending this again because the last time I had a typo in the subject line. I have been using this recorder for many months with good results. Last week I noticed that the I had to hit ...
...working Been years since I had an RD600 but I do remember it happened to me once or twice. It was either the SPLIT function...with one of the volume sliders down, or MIDI channel. Sorry not much of a ...
...the round one, then that is the ground to your amp. It will still work, however, the amplifier will not be properly grounded. So in a pinch you can use it, but you need to get the cable replaced. The ...
Question about EGX-30A Desktop Engraver
My Engrave is not working. After I switch on, all i see is the leds brinking and no control key works after this https://www.youtube.com/watch?v=p2xugw_Qw-Q EGX 30A Out Of Box Setup 1 of 3
Question about EGX-30A Desktop Engraver
...working properly, then the lack of a yellow indicator light may not be a problem. However, if the USB drive is not working properly, then the lack of a yellow indicator light could indicate a
Usually answered in minutes!
50 Questions
24 Questions
20 Questions
19 Questions
16 Questions