Questions & Answers for: Infiniti does not power on Cars & Trucks

...did not work. Any suggestions sounds like loose ground or power cable take volt meter and check battery if it has power check cables if not change battery could be dead cell good luck hope this ...

power to the motors they kicked on so I know their not dead. I believe it may be a relay but not sure if just the fan relay can be replaced. Appreciate any assistance. most likely a relay problem or a

...not getting power at all. The fuses are good - but I can't seem to figure what the other little compression type switch does...it's mounted right behind the brake pedal, but without it the ...

power-window-not.html ------------ Power windows not working after car wash?http://howtobyme.blogspot.com/2011/11/power-windows-not-working-after-car.html --------- power locks, power window and power

power out on the wire to the clutch, then the pcm is not grounding the relay. Make sure the PK/LB and R/Y wires have power in and out of the low pressure switch.---------------------------------------

...not charging no power steering? Two separate issues. If your battery is not charging when the car is running, you have a bad alternator. If you have no power steering, you have a problem with your ...

...lights will work with current flow in either direction starter solenoids need a direction to move in on starting so it will not work with the wrong direction of power radio could be blown ...

...not allow power to the fuel pump and no power to the spark plugs too. Why would you need to hotwire something that is already wired correctly in the first place. Some part is defective. You just ...

...power Well that does not make much sense. Your seats have power but nothing else. Have you check your main fuses. If it has no power your seats would not work. Might also check your battery wires for ...

...not getting power to the motor, you have a bad switch. If you don't have power to the switch, you might have a bad fuse. If you don't have power to the fuse, you might need to check a wiring diagram ...