Questions & Answers for: Juki needle shaft

needle has an "indent" in its shaft. I know the thread goes through from left to right. Where sits the indent? Since I changed the needle, the threads breaks. The indent is called the scarf. The scarf

...shaft raise the needle bar to the highest point,,then loosen the clamp screw to remove the old needle push the needle all the way up to the stop, or as far as it will go,then tighten the needle clamp ...

changing needle on juki tl98q How do I change the needle on the Juki TL98Q Push needle all the way up into needle bar shaft, flat side toward back. Firmly tighten screw to secure needle. Jimmy

...shaft.Push the needle all the way up to the stop or as far as it will go, then tighten the needle clamp screwupper tension may be to tightthe needle may be bent or damagedthread may be hanging up in ...

needle shaft to get it out? unscrew the retention nut all the way. use the back of a screw driver and tap tap tap....or use an earth magnet to try and get it out! theres a small hole in the needle bar

...needle slip out of the shaft when I was winding a bobbin, the wheel stopped and needle was jammed between the throat plate and the bobbin housing. I broke the needle to remove it all pieces are clear ...

When the needle reaches its lowest point and then starts back up about an eight of an inch. The point of the hook should be slightly above the eye of the needle and be directly behind the needle shaft

...needle thread tension not tight enough the jamming may be from thread and fluff wound tight around the bobbin shaft an locking it up remove any threads and other material from the bobbin shaft and ...

shaft motor encoder defective Angle counter of needle UP detection has exceeded the value equivalent to 1.1 turns. Angle counter of needle DOWN detection has exceeded the value equivalent to 1.1 turns

...needle shaft (above the screw)? Try lowering presser foot and advance hand wheel so needle is at its lowest position. Then take a clean dry rag and wipe around the shaft just above the screw and see ...