Questions & Answers for: Husqvarna needle shaft

...needle shaft and moving the shaft up or down to get the desired position relation of needle to hook don't turn the machine or that alters the hook position so leave it steady while moving the needle ...

...needle threader may have slid down the shaft. This take a special tool. I purchased mine at Sears tools. There are 2 screws on the back of the threader. Move the needle to the highest position and ...

...changing needle, 3 rotate shaft (needle out)manually slightly pull forward on shaft.it might have come disengaged Consult your manual. The flat side of the needle may be facing the wrong

needle shaft as changing the needle does not help. I think you need a repair/service person. Did you use a larger sharp needle when stitching? Top stitch needles are very good, also titanium coated as

...shaft that holds the needle is not stable and moves in all directions. Can someone please help? it's possible that in breaking the needles, it's could have broken or damaged,, it needs to be ...

...shaft.Push the needle all the way up to the stop or as far as it will go, then tighten the needle clamp screwupper tension may be to tight try 3 to 5the needle may be bent or damagedthread may be ...

...needle shaft, you watch it going up and down, can also move sidesways (but only a few mm's (about 3/16 inch)) The needle shaft should both go left and right, freely. It is hinged at the top but half ...

...shaft).Push the needle all the way up as far as it will go. Then tighten the needle clamp screw.adjust the top tension one number or letter at a time until thestitch looks normalif adjusting the top ...

needle falls out of the needle shaft Tighten the screw.

Needle threader doesn't move and stays in the low position. Husqvarna designer SE This could be due to one or more causes. 1. The return spring has come loose. 2. The threader shaft is bent. 3. Lint ...