Questions & Answers for: needle seat ATVs

Question about Quads 125cc Full Size Adult 4 Wheelers ATV

1 Answer

...90 degrees. Remove the float bowl and look at the carb from the side and adjust the arm to seat the needle when the floats are about where they would be as if the bowl were full of fuel. Good

Ad

Question about 2004 Bayou 300 4x4

1 Answer

...seat from the slide that holds the needle jet in place.. NOTE which groove the clip is in on the old needle.... (should be the middle one). re install the new needle, reinstall everything else and ...

Ad

Question about 2005 Bruin 350 Auto 4x4

1 Answer

...needle and seat make sure there isn't something keeping the needle from fitting snugly into the seat. Not sure if the tip of the needle is rubber or the seat it's self on this carb.. one or the other ...

Question about 2005 Bruin 350 Auto 4x4

1 Answer

to float bowl when float rises high enough). Some needle valve have a rubber tip on them that goes bad over time. Or, the needle or it's seat are just worn out, not fully shutting off the flow of fuel

Question about 2004 Sportsman 500 H.O

1 Answer

...from drain valve unless shut off This is caused by a bad needle and seat in the carb you can buy a carb kit and replace the needle and seat and it will stop leaking make sure not to bend the ...

Question about 200cc Full Size Four Wheeler ATV

1 Answer

...needle and seat out of a ymaha kodiak 400 Take the float bowl off the carb. Pull the pin that holds the float on. The needle is attached to the float. The needle just came out of the needle seat. The ...

...needle or seat, If carburetor has been taken off the float setting could be off, gas breaking down leaving a deposit on the needle or seat. Usually can be cured with a good cleaning and a new needle ...

Question about 2008 Sportsman 500 H.O

4 Answers

...needle and seat are worn or the float is ruptured an sinks to the bottom of the bowl. The needle and seat, along with the floats,are the only mechanical part that stops the fuel flow. too late to use ...

...needle and seat area where the fuel supply is not being controlled remove the needle and seat and clean all dirt and rubbish from the needle ans seat area could come from rust and dirt in the tank so ...

needle and seat in your carby, You need to pull your carby off and unscrew the bottom half from the top, 1st sign of a needle stuck inside the seat is a dry carby There you'll find the float, push the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...