Question about 6015 Mechanical Sewing Machine
...bottom plate I found a small spring laying on the bottom plate. can't locate where it belongs? I rwmoved the needle and same malfunction. Email me for timing instructions ...
Question about 3537 Mechanical Sewing Machine
...needle is bent & needs to be replaced. check your throat plate to see if there are any burrs on the plate because they can snag the fabric if you feel any burrs on the plate take it to a service ...
...needle plate area that's where the feed dogs are, if the feed dogs are up where you can see them & even feel them with you fingers when you rub your fingers over the needle plate area, if you ...
...into two needles. MAKE sure you have Zig Zag needle plate installed to accomodate the double needle. Turn hand wheel slowly to test then use thread and fabric and turn flywheel by hand to test
Question about 3101 Mechanical Sewing Machine
...needle plate the thread is picked up by the hook(sharp, under bobbin). If the hook and needle aren't in the right position the thread won't be picked up. Open up your needle plate and use your hand ...
...in your needle plate where you have broken a needle. Check needle plate and clear snag if any. Then tighten up your needle thread tension until both needle and bobbin threads are in middle of
Question about 6030 Mechanical Sewing Machine
: http://www.sewingpartsonline.com/necchi-sewing-machine-parts-model-list.aspx Necchi Home Sewing Machines www drdanessmh com Necchi needle plate You might also look on eBay: necchi 549 needle plate .
Question about 6030 Mechanical Sewing Machine
...needle plate or presser foot or gets bent or damaged.
Make sure the needle, thread, and fabric are compatible, ie do not use ball point needles on woven fabrics, do not use a needle which eye is ...
Question about 6030 Mechanical Sewing Machine
...need of a Necchi 538/539 needle plate as shown in picture. Unfortunately, it may be difficult to find: https://www.sewingpartsonline.com/needle-plate-necchi-nz33lg.aspx ... I have a 538 model for ...
Question about 6030 Mechanical Sewing Machine
...needle plate: Make sure that the needle plate is clean and free of any debris or burrs that could prevent the needle from seating properly. Check the needle alignment: Make sure that the needle is ...
Usually answered in minutes!
111 Questions
91 Questions
75 Questions
56 Questions
44 Questions