Questions & Answers for: Juki needle hook

...hook behind the needle hole. the tip should be as close to the needle hole as possible without actually touching the needle (6) tighten screws (7) slowly hand turn the machine (depress the foot pedal ...

...needle the hook will now hit the needle and damage the hook point - use the correct needle style. if you are sewing thick canvas or upholstery you may require a much larger needle such as 120, 140 or ...

...needle and hook ( bring the lower mark aquel with lower needle bar bushing at this point the tip of hook must be at the center of needle and the distance between the tip of hook and groove for needle ...

...thread breaks its usually the needle is bad. also check hook with finger for burrs caused by the needle. burrs will cut the thread right away. use emery paper and rub in direction of hook till

...needle passes presser foot. burrs on hook under machine causesd by breaking needles. tilt machine and use emery paper to smooth hook. stroke in same direction as hook rotation. maybe too much top ...

as it comes around. If you use too large a needle (larger than an 18) it will sometimes break the needle because the hook is actually coming around and hitting the needle too close and breaking it off

...bar guide. when u have the needle in this position u have to loosen the hook ( 3 screws) and place the point of the hook just meeting the needle. before u try this try lowering the needle

...needle and hook interplay. unthread needle for this. the hook should be about 1/16 from needle before the needle starts to rise.. good luck on setting the timing i can't even do that. since its a ...

...needle and tighten hook screws. machine must be tilted back to do this whole operation. it helps to have a short screwdriver to tighten the hook screws. remove burrs with lite emory paper stroking in ...

...needle. Tighten the screws on the hook, put the machine back down (make sure that you have put your bobbin case back in) and test to see if you can pick up a thread when you wind your hand wheel ...