Questions & Answers for: needle holder Coffee Makers & Espresso Machines

...holder problem. Needle hits bobbin holder and doesn't grab the bobbin thread. It will break the needles if persisted. Is the needle all the way up in the holder? Have you checked the timing with the ...

...needle holder on Bernina 160 1.) Remove the screw that holds the needle in. Remove needle. 2.) Gentle pry the thread guide clip off of the needle holder. There is a guide and a small flat spring, do ...

needle holder screw, remove needle making note of the direction of the flat side if your needle has one.  Put new needle up there as far as you can get it... tighten down the needle holder screw.

needle holder cannot be turn to the highest point I unfortunately broke 2 needles. i successfully took the needles out and when i was about to put the 2 new needles- i cannot put it as the holder ...

...needle holder and tightening the needles up and that will let you know if the needle holder is working or not and if the needles don't stay up into the needle holder like their suppose to then the ...

...overlocker my needle broke so I changed it now it wont sew check to see if the needle is turned the right way in the needle holder and that the needle is pushed all the way up into the needle

needle holder correctly and tightened into the needle holder correctly.. if the needle was in the needle holder correctly and it's still hitting the bobbin carrage then the machine needs to be checked

...needle holder in my Euro-pro ep550 will not tighten to hold the needle in the machine. how ill i buy another needle holder to fit my machine my machine is a overlock serger and hold 2 needles but I ...

...needle holder 5. The needle thread and the bobbin thread are not set under the presser foot when starting sewing 6. The threads were not drawn to the rear after sewing 7. The thread is either too ...

...needle holder. I'd had a Kenmore for years and believe I put the needle in the same way. flat side toward the right (although I tried all directions), ensure the screw is released and look for the ...