Questions & Answers for: nec vt440

NEC vt440 projector is overheating After about 30 minutes of use, the projector turns off. I assume it does so because it is overheating and needs to cool. Is it possible to replace bad fans? Or, ...

Ballast Assembly Replacement I can't find a ballast replacement anywhere. Part number D9288BM-01. Is it possible to get parts like this? post the number on ebay see if any are availble

no image I am currently connected via the S-Video, but I can not get an image to show. Can you please help me figure out what I am doing incorrect? Thanks try switching your input source and make sure

NEC VT440 projector problems can you help Ive just bought a NEC VT440 projector from ebay uk now the power light is always orange and the status light is flashing red ive looked at the bulb it seems ...

...NEC VT440 projector from ebay uk now the power light is always orange and the status light is flashing red ive looked at the bulb it seems fine ive check the air vents seem fine, ive followed the ...

...VT440 says this when it gets to it's pre-defined service life. (a certain amount of hours) As long as you pop the filters out regularly and clean them (I use a vacuum cleaner) you shouldn't need to ...

nec projector vt440 wont turn on status lite on red power on orange whats up with it Hello. First check the lamp! From your description, it sounds like the projector is telling you that the lamp needs

VT440 NEC PROJECTOR PROJECTOR WAS LEFT ON OVER NIGHT AND I THINK LAMP WAS BURNED OUT ALTHOUGH THE NIGHT BEFORE IT READ 90 PER CENT LIFE LAMP LEFT . IT WILL NOT WORK NOW. let it cool down then remove ...

I have a NEC MT840 Projector. I cannot get it to focus. What should I do? are you adjusting the slider in the front for manual focus?

have a problem with my nec vt 46 projektor, the lamp dosent work! i have checked the manual and according to the troubleshooting i have a "lamp error" where it sais that i should wait a full minute ...