Question about MultiSync VT45 Multimedia Projector
NEC VT45 projector There is a flashing red light on our school's VT45 projector. The lamp has been replaced but the flashing red light remains. Any suggestions to try? make sure the doors are shut all
Question about (MTLAMP820/1020) Projector Lamp for MT820, 102
nec projector vt590 doesn't project RED 18 month old nec vt590 projector that's been used less than 100 hours doesn't project RED, just BLUE and GREEN. On occasion the RED will flash in for a moment, ...
...flashing red status light and no lamp The projector will turn on and the start up process is normal until the light should turn on. Then status light which started out green begins to flash red. The ...
...projector weather or not to power up depending on the hours its counted, i have not yet found a way to reset the chips even by reprogramming them, i'm afraid the only solution is to replace the ...
NEC vt 595 was working fine last night and today i went to turn it on the status and power light started flashing red and orange and there is no picture if Power is flashing orange - then it's cooling
...NEC VT 800 projector hooked up to a smartboard. When I turn the projector on the green power button will come on. Then the red status indicator light will flash 6 times. The bulb will not come on. ...
...NEC NP100 LED light is flashing RED and it is suggesting that the lamp has gone. I have looked atthe lamp hours and there are displaying over 3000 hrs. Have changed the Lamp but the Project still ...
...NEC technical support, if the status light flashes red six times, this could indicate a defective lamp. If a new lamp is installed and the project still won't turn on, the projector will need ...
...projector comes on and never fully comes on then shuts down and red status light keeps blinking Below is the manual. go to troubleshooting on pg 56 and you can find out what the flashing LED means. ...
NEC VT676 I have tried numerous new bulb in numerous projectors. Have tried holding down "help" for at least 10 seconds to reset the bulb hours. Could these non-OEM bulbs be causing the ballast ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions