Questions & Answers for: nad c370

NAD C370 Right channel distortion Hi, bought this amp as new old stock last week. Worked fine for a few days. After leaving switched on unused for 3 or 4 days I noticed the protection light was red. ...

NAD C370 Amplifier When I switch the amp on it makes a loud buzzing sound that comes from within the amp itself and also comes though the speakers. It gradually fades away over a couple of minutes. ...

Nad C370 Hi, I have a NAD C370 that goes into protection after around 30 mins, sometimes more or less depending if the volume is higher or lower. I found this article... ...

NAD C370 Hi I've had my NAD C370 for years and just yesterday when I turn on the power button, nothing, its absolutely dead, no lights, no noises, dead to the world. I've read through some articles in

Knob for NAD amp? I'm looking for a knob for a NAD 3130 amp. Any ideas? Hi... try your "local" NAD seller and ask them? Contact NAD by email. or www.audiokarma.org 100's of users someone there should ...

...NAD C370 amp overheats and under powers one of the speaker on the second set of speakers. Any ideas or estimate what required to fix? They have been great up to now. over heating is a sign of ...

...NAD C370 is not working, will the amp still work if I remove the balance pot? Only if you replace the pot with two resistors of equal value. Both need to be also equal to 1/2 the value of the pot. ...

nad c370 keeps switching off amp keeps switching off Check the speaker wiring for shorts, a common problem. If everything checks out there may be bad solder joints on the main board especially in the ...

NAD C370 distortion Check first if you got +68/-68V on amp module left and right on contact CZ302 and CZ402 pin 2 & 7. Often the -68V is missing. This is caused by faulty transistor Q713 in ...

...NAD C370 and both channels have gone silent. All the lights remain green when steady, but but sound to speakers, but headphones still work. When I switch on, the power light is amber, then 1 solenoid ...