Question about PIXMA MP530 All-In-One InkJet Printer
...inner cover is open message when it is closed i changed the ink and now I am getting the message that the inner cover is open when I go to print and because of that I can not print. I have turned the ...
Question about PIXMA MP530 All-In-One InkJet Printer
INNER COVER IS OPEN FOLLOWING CHANG IN INK I RECEIVED A LOW INK MESSAGE. I REPLACED BOTH BLACK INK CARTRIDGES. NOW, THE MESSAGE REMAINS LOW INK AND INNER DOOR IS OPEN. The inner door is the CD tray ...
Question about PIXMA MP530 All-In-One InkJet Printer
...inner cover is open" what can I do? Hi Sir, This Inner Cover is actually the plastic door which is usually opened to install or remove the ink cartridges. This door or cover must be open or not ...
Question about PIXMA MP530 All-In-One InkJet Printer
...inner cover is open. How do I close it. The inner cover is the flap that you drop down to replace inks, there's a small switch on the right inside that goes bad, you can try opening and closing a few ...
Question about PIXMA MP530 All-In-One InkJet Printer
...Inner cover is open. Close the inner cover and press OK." I closed the tray and press OK, it still displays the same error. Power cycling the printer doesn't help. Are you sure you closed the tiny ...
Inner Cover is Open. The inner cover is NOT open. The last time I got this error message (weeks ago), I finally unplugged the machine for over 10 seconds, and then it functioned properly. I tried that
Question about PIXMA MP530 All-In-One InkJet Printer
...inner cover is open"? Closing the inner cover to clear error messages. Raise the Scanning Unit until it stops. (A) Press the Open Button to open the Paper Output Tray if it does not open ...
...mp530 error 6500 The 6500 error code is a logic board error code. The PCI Bus error is detected by the ASCI. Sounds like it needs new logic board. Solution is first of all you can try to reset your ...
...MP530 is located inside the printer, as shown below. Lift the Scanning Unit (Printer Cover) until it locks into place. When the printer is powered on and the Scanning Unit is lifted, the Paper Output ...
Inner Cover is Open on printer screen. It is not open?? check the sensor that is the Inner Cover, you may have fallen out of place it is
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions